SE: +46 8 6533209

Reference projects

Back to the project list

Piercing of aerosol cans

  • Punching a round hole into a can
    Punching a round hole into a can
  • TOX®-Press type CMM 008
    TOX®-Press type CMM 008
  • The punching tools
    The punching tools

Information on the project

The customer is producing aerosol cans.

The cans can only be pierced after a pressure test. The punches dive through the upper opening into the can and make the piercing at the bottom simultaneously. The approach – power stroke combination of the TOX®-Powerpackage provides the short cycle time at a total stroke of 300 mm. Additionally, 3 different types of cans can be pierced with 2 tool sets.


TOX®-C-Frame Press CMM 008 

Drive: TOX®-Powerpackage S 008 with press force 80 kN (at 6 bar air pressure), total stroke 400 mm and power stroke 12 mm.



The cans are transported from a feeder to the indexing table which positions two pieces in the piercing tool.




Products: Pneumohydraulic drives
Products: Presses and Systems
Industries: Home appliances and other industry
Applications: Punching
Our customers are our reference
  • Logo Audi
  • Logo AWL
  • Logo Blum
  • Logo BMW
  • Logo Bosch
  • Logo Brose
  • Logo BSH
  • Logo Comau
  • Logo Continental
  • Logo EBM Papst
  • Logo Electrolux
  • Logo Faurecia
  • Logo FFT
  • Logo GM
  • Logo Hettich
  • ifm Tettnang, Kunde von TOX PRESSOTECHNIK
  • Logo KUKA
  • Logo Mercedes Benz
  • Logo Opel
  • Logo SEAT
  • Logo VDH
  • Logo VW
  • Logo Whirlpool
  • Logo ZF


Servogatan 14
19560 Arlandastad
Phone: +46 8 6533209
Fax: +46 8 6502745
SE: +46 8 6533209 Contact form
Cookie Information

We use cookies to give you the best possible experience when using our website. You can block or regulate the use of cookies by adjusting your browser settings accordingly.